AutoBlinds.

07 / PCB

The printed circuit board.

The AutoBlinds PCB carries an ESP32 module for control and BLE, a TMC2209 stepper motor driver for the actuator, and screw terminal blocks for power and motor coils. Below: schematic, 2D board view, and 3D render.

7.1 / Schematic

Schematic.

PCB schematic showing TMC2209 stepper driver and ESP32 pin headers 1TMC2209 2Capacitors 3Screw terminals 4ESP32 headers
Fig 7.1 / Schematic Two main blocks: TMC2209 stepper driver subsystem on the left, and ESP32 pin-header / power input section on the right.
  1. 1TMC2209 stepper driver (U4) receives STEP/DIR signals and drives the motor coils via M1A/M1B/M2A/M2B
  2. 2Decoupling capictors C7 (100 nF) & C8 (100 µF) stabilize VM and 3.3 V rails near the driver
  3. 3Screw terminals J10 & J11 for VM/GND power input and motor coil output
  4. 4ESP32 pin headers J16 & J17 exposes IO pins, UART, and 3.3 V / 5 V / GND
7.2 / Board layout

Board.

PCB board layout — top copper view 1TMC2209 2Motor terminal 3Power input
Fig 7.2 / Board layout Top copper view. Pin headers run along both long edges; the ESP32 module sits in the middle of the board, with the stepper driver and screw terminals along the bottom.
  1. 1TMC2209 driver footprint surface-mount pads with R6 resistor and routing visible above
  2. 2Motor screw terminal (J11) which is a four position block exposing M1A / M1B / M2A / M2B coil connections
  3. 3Power input (J10) which is VM / GND screw terminal
7.3 / 3D render

3D view.

PCB 3D rendered view 1TMC2209 2Resistor 3Screw terminals 4Silkscreen
Fig 7.3 / 3D render Realistic view of the assembled board. Used to verify component clearance and mechanical fit inside the 3D printed enclosure.
  1. 1TMC2209 stepper driver through hole-mounted in the center of the board
  2. 2R6 and decoupling capacitors C7 / C8 used for filtering and stabilizing the power supply
  3. 3Screw terminal blocks power input (VM / GND) and motor coils (M1A / M1B / M2A / M2B)
  4. 4"Team 4" silkscreen and pin numbering / labels printed in white silk